Ramadi Group
Guide

How to Reset a Rational Combi Oven

A frozen display, a failed self-test or a gas fault does not always mean a repair. This guide covers the safe resets operators can try on Rational combi ovens, and the point where you should call an engineer.

Before you reset anything

Resetting clears a temporary fault. It does not repair a failed part. If the oven shows the same message again after a reset, stop and have it checked: repeated resets can hide a problem that is getting worse.

Check the simple things first. Is the isolator switched on? Are the water and gas supply valves open? Is the door closing properly, and are the trays or racks seated correctly? Make a note of any message shown on the display before you do anything else, because the engineer will need it.

The basic restart

For a frozen display, odd behaviour after a power cut, or a one-off glitch, the first step is to switch the oven off, wait about a minute and switch it on again. This clears many temporary faults and does not normally affect your saved programs and settings.

On start-up the oven runs a self-test. Do not open the cooking chamber door during the self-test. Opening the door makes the self-test fail; to try again, switch the unit off and on again and leave the door shut.

Resetting a gas fault

Gas ovens have an automatic ignition system that locks out if the burner fails to light. On SelfCookingCenter models of the older type, a “RESET GAS” prompt appears on the display; after a short delay you will hear a beep and can press the prompt to restart the ignition sequence. On CombiMaster Plus models the equivalent is a clock button with “rES” on the display. On iCombi Pro and iCombi Classic models, the reset button sits in the service level, under gas parameters or function control respectively.

Try a gas reset once. If the burner does not light, or the fault returns, do not keep pressing reset. Isolate the gas supply at the valve and call an engineer. If you can smell gas at any point, close the supply, ventilate and leave the area before calling for help.

Water and drain faults

If the message points to water supply or drainage, check that the water tap is open, that the drain is not blocked and that the drain hose is not kinked. Hard water scale is a common cause of repeat faults in this region, so a descaling routine and good water treatment pay for themselves quickly.

When to call an engineer

Call for service if the same error returns after a restart, if the oven will not heat or ignite, if water leaks inside or outside the unit, or if there is any smell of gas or burning. Our engineers repair and maintain Rational combi ovens in Dubai and across the UAE, and our parts team can source common spares.

A note on models

Rational has produced several generations, and the display and procedure differ between them. Always follow the operating instructions supplied with your unit and, where in doubt, ask. This guide is general information from Ramadi Group, which is an independent service and parts company and is not affiliated with the manufacturer.

Talk to our team in Dubai

Call +971 4 884 0555 or send us your requirements.

Request a quote